REAR CABINET CONVECTION
DUCT
| FOAM TAPE ON |
| THIS FLANGE |
FORWARD |
|
CONVECTION |
|
DUCT | FOAM TAPE ON |
| |
| THIS FLANGE |
SCREW HOLE |
|
|
| HORIZONTAL CLIP |
|
| ORIENTATION |
|
| ON MOUNTING |
25 3/4" |
| BRACKET |
1/8" HOLE FOR |
| |
|
| |
| MOUNTING | TOP PIN |
| SCREW | OF TRIM |
FOAM TAPE ON | CENTER |
|
THIS FLANGE | LINE |
|
INSERT 4
MOUNTING BRACKET 
SUPPORT
TRIM KIT
ASSEMBLY
BASE | INSERT 1 |
BOTTOM PIN OF TRIM
SCREW HOLE
FLANGE
TRIANGULAR
TOP SCREW CENTERING NOTCH
LOCATE MOUNTING BRACKET
IN BOTTOM CORNERS
OF CUTOUT
CABINET
INSERT 2
HORIZONTAL
CLIP ORIENTATION
ON BASE
INSERT 3
Stainless Steel Care
This Trim Kit is made of stainless steel. Use the mildest cleaning procedure first. Start with hot soapy water, rinse and dry. If the trim kit has food soil remaining, try a general kitchen cleaner, such as Fantastik®, Simple Green® or Formula 409®. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly in the direction of the grain. Do not use a steel wool pad, it will scratch the surface. To touch up noticeable scratches in the stainless steel, sand very lightly with dry 100 grit emery paper, rubbing in the direction of the grain. After cleaning use a stainless steel polish, such as Stainless Steel Magic®.
