Painting the Grille:
1.The grille of the IWSub Reference features an even, protective powder coating. This powder coating is an ideal primer.
2.Grilles must be spray painted. Do not use a brush and paint. Thick, brushed paint may clog the grille holes and impair performance.
3.After removing the grille by care- fully hooking it with a bent paper clip and pulling it gently away from the frame, spray on two thin coats of finish color. [Figure 9] If you’re using a compressor and spray gun, use the finest, most dif- fuse setting. Be careful not to fill the holes in the grille with paint.
4. When paint is completely dry, | Figure 9 |
carefully reinstall the grille. |
|
Troubleshooting Your IWSub
•If, after following these hookup and installation directions, you experience difficulty, please
•Check the setting of the “Auto/Remote” slider switch on the rear panel of the SubAmp 600. If no remote connection is made, this switch MUST be set to “Auto” in order for the SubAmp 600 to operate properly.
•Many amplifiers and receivers have sophisticated internal protection circuitry. If for some reason your protection circuitry is tripped, turn down your system’s volume level and wait five minutes before restarting the system.
•If you are still having problems, please contact your authorized Definitive Technology dealer for assistance.
11
