Figure 5 | Figure 6 |
6.Once you have cut the hole, fish your previously positioned wiring out of the hole and connect your speaker. See the next section for detailed hookup instructions. Make certain that you connect the wire from the red terminal (+) of your SubAmp 600 to the red terminal (+) on your speaker and the wire from the black terminal
7.Place the subwoofer carefully into the hole [Figure 5]. Secure the sub enclosure using the 6 screws provided. These screws go into the holes in the front of the enclosure and angle back into the studs (or, if the space between your studs was wider than
8.Secure the locking arms at the top and bottom of the plastic frame by turning the screws clockwise, taking care not to over tighten.
Making System Connections With Your
SubAmp 600
Recommended Hookup Method One
1.Use a Low (Line) Level RCA connection from your receiver’s LFE Out in to the LFE Input of the SubAmp 600.
2.Use Speaker Wire to connect the top set of Sub Out Jacks on the SubAmp 600 to the terminals on the IWSub Reference.
3.The SubAmp 600 features an Adjustable Crossover setting on its front panel. This hookup bypasses the SubAmp 600’s Adjustable
6Crossover feature.