Connecting Each Speaker with One Pair of Speaker Wires Only
With all the gold jumpers in place (see Diagram # 1), simply connect any of the red (+) terminals of each speaker to the red (+) terminal of its channel on your amplifier or receiver, and any of the black
If you have a Dolby Digital system, “tell” your bass management system that you have “Large” left and right front speakers and “No” subwoofer. The base management system will then send the LFE .1 channel signal into the left and right channels, and it will be reproduced by the subwoofers in your BP7000SC/ BP7001SCs, giving you all the benefits of Dolby Digital and the discrete LFE signal.
When the speakers are hooked up using simply one set of speaker wire per speaker (with no separate low level input for the subwoofer section), a special circuit takes an infinitesimally small signal from the speaker level input and converts it to a
+
-
Left Right | Power Amplifier | |
or Receiver | ||
|
Diagram # 1: Connecting Each Speaker with One Pair of Speaker Wires Only
7