Definitive Technology SSA-42 Positioning the SSA, Wall Mounting the SSA, Definitive Technology

Definitive Technology SSA-42OWNER’S MANUAL

Positioning the SSA

The SSA speaker may be mounted on the wall above or below the video screen.

It may be placed on a table or shelf in front of the TV.

If placed on a shelf under a TV, adjust the leveling feet (screwed all the way in) to aim the speaker up towards the listeners.

The SSA speaker may be placed directly on top of TVs that have at least 5-inches (13 cm) of flat surface on top. Do not place the SSA speaker on top of any surface that is not large or stable enough to securely support the speaker. If the speaker seems at all unstable or “tipsy” place the speaker somewhere else. The

warranty does not cover damage caused by falls due to improper

positioning of the speaker. If the speaker is above seated listener height, extend the leveling feet to point the speaker downward [See Using the Leveling Feet on page 3].

Even if you intend to place the SSA speaker on a TV or shelf you must attach the wall-mount bracket to the speaker. See Using the Leveling Feet on page 3.

Wall Mounting the SSA

•We recommend that the SSA speaker be wall mounted

by professional installers or by those appropriately skilled in the use of power tools and who have knowledge of building codes and structural issues.

•We recommend that you determine a suitable location for your speaker installation, and that you complete all wiring (especially “hidden” in-wall wiring) before mounting the bracket to your wall.

•Mythos Brackets are not suitable for ceiling mounting.

The Mythos Solo Surround Array loudspeaker comes with a wall mounting bracket and template that makes secure mounting a breeze. Follow these directions for installing the wall mounting bracket.

+ SURROUND RIGHT – + FRONT RIGHT – + CENTER – + FRONT LEFT – + SURROUND LEFT –

THREADED INSERTS

1/4" – 20 SCREWS BACK OF SPEAKER

TOP OF SPEAKER

1.Two 1⁄4"–20 screws have been factory installed on the back of the speaker. Gently hand-turn the screws to make sure they are in as far as they can go. Do not force them beyond the “stop” point.

The screws cannot screw all the way into the speaker and should protrude as shown in the illustration.

2.Make sure the location you have selected for wall-mounting does not conceal behind-wall electrical wiring or plumbing.

3.Hold the cardboard template (included) in the intended location. Make sure the speaker clears the ceiling, adjacent walls, corners, beams, lighting fixtures and door/window frames. Leave at least 11/2" (38 mm) above the speaker location to allow the speaker to slide down onto the bracket.

4.Make sure the center of the template is perfectly centered with

2 the TV screen.

PILOT SLOTS

5.Use a bubble level to make sure the template is level. If the TV is wall mounted and not level, the speaker will look better if it is off-level in exactly the same way as the TV.

6.Use push pins to secure the template to the wall.

7.Mark the location of pilot holes noted on the Mounting Template with a pencil; remove the template.

8.Pre-drill the pilot hole locations for mounting screws (not included). Use screws rated to hold securely in the wall material (we recommend #10 screws).

9.It is best if at least one screw hits a wall stud. If there is no stud behind the pilot hole location, install wall anchors (not included) to secure the bracket screws. Follow the wall anchor manufacturer’s directions. Each wall anchor should be rated to hold at least one-half of the product net weight

[see specifications on front cover].

10.For masonry walls, use a masonry drill bit to pre-drill holes, and use masonry anchors and screws (not included).

11.Pull the five sets of speaker wires through the hole in the bracket.

12.Screw the bracket to the wall.