Before fitting the chimneys, connect up the outlet ducting (if required) and insert the fitted plug into the wall socket.
•Remove the protective film from the chimney ducting taking care not to dam- age the polished stainless steel surface.
•Fit the upper chimney duct section (the one with louvre outlets) to the ceiling mounting bracket using the screws sup- plied.
CEILING MOUNTING BRACKET
TOP CHIMNEY DUCT 
•The lower duct fits over the extractor hood motor assembly and over the upper duct. Take care not to scratch or damage the hood and upper duct surfaces.
•Loosely attach the lower duct bottom edge to the hood by four self tapping screws through four holes on the inside of the extractor hood .
INSERT 6 SELF TAPPING SCREWS
•Fit the lower chimney duct to the lower wall mounting bracketand tighten the six screws on the inside of the extractor hood
•Drill 3.5mm Dia. holes through the top holes in the bottom chimney and through the lower end of the top chimney duct.
•Fasten the two chimneys to the centre chimney bracket.
Top chimney duct
Drill two 3.5mm Diameter
holes and secure two chimney
ducts to mounting bracket.
Mounting bracket
Bottom chimney duct
Page 5
