Defy Appliances DCH285, DCH261, DCH260, DCH284 owner manual Installation sequence

Installation..

Installation sequence;

1.Extractor unit / chimney brackets.

2.Top chimney duct

3.Bottom chimney duct

•Carefully remove the extractor hood and the components from the packaging.

•Remove the grease filters.

CEILING MOUNTING TEMPLATE

CEILING MOUNTING

BRACKET POSITION

•	In a similar fashion stick the hood mount-
	ing template on the wall ensuring that the
	centre-lines line up with those drawn on
•	the wall.
	Note that the holes marked on the tem-
	plate cater for both 600mm and 900mm
	wide models. Please ensure that you only
	use those markings relating to the model
	you have purchased.
	Holes for Triangular 600 are marked
	with a (1).
	Holes for Triangular 900 are marked
	with a (2).

CUT TEMPLATE

HOOD TEMPLATE

TOP OF CEILING

	Holes not marked are common to all
•	models.
	For mounting the chimney brackets, drill
	6 holes, 5mm in diameter and 45mm deep
	into the wall as indicated on the mounting
•	template.
	For mounting the extractor hood, drill 4

LINE FROM CENTRE OF STOVE TO CEILING

750

HORIZONTAL LINE

•Draw a fine vertical line on the wall from the rear-centre of the hob to the ceiling.

•Draw another line, horizontal this time, where the bottom edge of the hood should be. (A minimum distance be- tween the hob and the hood of 750mm is recommended.)

•Take the template card and separate the ceiling mounting template from the hood mounting template by cutting along the indicated line.

•Using masking tape, stick the ceiling mounting template to the wall directly below the ceiling and centered on the vertical line.

	holes, 8mm in diameter and 60mm deep
•	as indicated on the mounting template.
	Once all the holes have been drilled the
•	templates must be removed.
	Push the 5mm Dia. wall plugs through the
	holes in the chimney mounting brackets.
	Insert the plugs into the drilled holes to-
	gether with the chimney mounting bracket
	and fasten securely.
• Push the 8mm Dia. wall plugs into the
	8mm Dia. holes ensuring that they are
•	flush with the wall.
	Partially screw two 6mm Dia. screws into
	the two top wall plugs leaving them to
•	protrude about 10mm.
	Lift and hook the extractor hood over and
	onto the two protruding screws through
	the key-hole slots provided at the top of
	the extractor hood frame.
• Insert the other two 6mm Dia. screws
	through the holes inside the extractor
	hood housing and into the 8mm Dia wall
•	plugs.
	Align the extractor hood with the centre
	and horizontal lines before tightening all
	four 6mm screws.

Page 4