AT&T 9110 Setting up the Cordless Telephone, Connect the telephone line cord, Before use

INSTALLATION

Standard power outletPower cordTelephone line cord Telephone jack

Strain relief hook

Power jack

1 Setting up the Cordless Telephone 9110.

• Choose an area near an electri- cal outlet and a telephone jack.

• The outlet should not be controlled by a wall switch.

2Connect the telephone line cord.

• Insert one end of the telephone

line cord into the jack at the rear of the base unit. Plug the other end into a telephone jack. Make sure the plugs snap securely into place.

3	Connect the power cord.
	• Plug the AC power adapter into
	a standard electrical outlet and
	the DC connector into the
	power jack located at the
	rear of the base unit.
	• Wrap the power cord around the
	strain relief hook on the bottom
	of the base unit (see illustration).	Clips
	The strain relief hook helps
	protect the power cord from
	accidentally being removed.
CAUTION: Use only the AC power
adapter supplied with this telephone.
This is a Class 2 AC adapter, specifi-		• Place the handset battery pack
cally designed for use with the 9110.
		in the compartment. Make sure
NOTE: Connect power to the base		the metal contacts on the
unit before placing the handset in		underside of the battery are
the cradle.		aligned with the charging
4	Set the dial mode switch.	contacts in the handset battery
	If you have touch tone service on	compartment.
	your phone line, set the switch	• Replace the handset battery
	located on the bottom of the base	cover by sliding it on its track
	to TONE. If you have rotary	up and over the handset battery
	service, set the switch to PULSE.	compartment until it snaps
5	Install the handset battery.	firmly in place.
		6 Charge the handset batteries
	• Remove the handset battery
	cover by pressing the	before use.
	indentation on the handset	Place the handset in the base unit
	battery cover and sliding the	cradle either in the face up or face
	cover downward.	down position. Make sure that the

Telephone jack

Slots

Base unit

Slots

Tabs

Reversible base

Thicker end

IN USE/CHARGE light on the base is on. The handset battery must be charged a minimum of

6 hours before using your phone for the first time. The batteries recharge automatically whenever the handset is placed in the base unit cradle.

7Check for dial tone.

After the batteries are charged, pick up the handset and press . The PHONE indicator should light up, and you should hear a dial tone. If not, see “IN CASE OF DIFFICULTY" in this manual.

1