CAUTION:
1Never install telephone wiring during a lightning storm.
2Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3Never touch uninsulated telephone wires or terminals unless the tele- phone line has been disconnected at the network interface.
4Use caution when installing or modifying telephone lines.
Wall Mounting
1Choose a spot where the telephone wall jack is near an electrical outlet.
This phone requires a modular telephone jack and a standard electrical outlet (120V AC).
2Remove the reversible base.
The reversible base is designed for
INSTALLATION
continued
both table and wall mount installa- tions. The telephone comes with the reversible base installed in the table mount position. To wall mount this telephone you will need to remove the reversible base and position it so that the thicker end is toward the front of the telephone (see illustration on previous page). You can remove the reversible base by depressing the clips on each side of the base while gently lifting upwards.
3Reattach the reversible base.
•Insert the tabs of the reversible base into the slots on the bottom of the telephone base.
•Gently press the thicker end of the reversible base until it snaps firmly in place.
4Connect the telephone line cord.
•Using the short telephone line cord supplied, insert one end of
the telephone line cord into the telephone jack on the rear of the telephone base.
•Feed the remaining line cord to the rectangular opening by pressing the line cord into the grooves of the reversible base leaving at least 3 inches free. Plug the line cord into the standard wall jack.
5Connect the power cord.
Plug the power cord into the jack on the back of the base. Plug the AC adapter into an electrical outlet.
6Mount the telephone to the wall jack.
Position the telephone base so the mounting studs on the wall jack fit into the reversible base. Slide the telephone down on the mounting studs until the phone locks in place.
TELEPHONE OPERATION
Making a Call
1Press 
on the handset and wait for the PHONE indicator to go on.
2When you hear a dial tone, dial the number.
NOTE: When another extension is in use on the same line, and the Cordless Telephone 9110 is in standby mode, the PHONE indicator on the handset will flash. The IN USE/CHARGE indicator will not function when the handset is out of range.
Answering a Call
If the handset is in the base:
NOTE: The IN USE/CHARGE indicator will increase intensity with the incoming ring.
1Lift the handset.
2The PHONE indicator goes on and the call will be connected.
If the handset is away from the base:
NOTE: The IN USE/CHARGE indicator will flash with each incoming ring.
Press any key on the handset (except
, volume control or 
). This is very useful in a dark environment; you do not have to fumble around
looking for the 
key to answer the call.
Ending a Call
If you are near the base: Place the handset in the base.
If you are away from the base:
Press 
.
Volume Control
The Volume Control allows you to increase or decrease the loudness of an incoming voice.
Handset Receiver Volume Control (located on the left side of the handset)
1To increase the sound level, press
the 
key.
2To decrease the sound level, press
the 
key.
3
