MEMORY
Memory Features
This telephone can store 21 telephone numbers, each up to 20 digits long.
Numbers will remain stored in memory unless you erase or change them by entering other numbers.
Programming a Number
into Memory
Make sure the handset is 
.
1Press 
. The PHONE indica- tor will blink to indicate that you are in the programming mode.
2Enter a number button
3Enter the phone number (up to 20 digits).
4Press 
to store the phone number to the key you selected. The phone now exits program- ming mode and emits a tone.
NOTE: If programming is unsuccess- ful, the unit will generate an error tone.
NOTE: You may choose to store emergency numbers in memory locations. The manufacturer assumes no responsibility for customer reliance upon this memory feature.
Quick Memory Dialing
The 
key gives you one button access to the speed dial number stored in memory location “00.” This may be a frequently dialed friend, business, or emergency number, such as 911.
There are two ways to dial using the 
key.
1Press 
.
2Press 
. The phone number stored in memory location “00” will be automatically dialed.
— OR —
1The handset must be 
.
2Press 
. The phone number stored in memory location “00” will be automatically dialed after a
Dialing a Number Stored in Memory
1Press 
to get a dial tone.
2Press 
.
3Press the number button
For example, to dial the phone number you assigned to button
“06,” press 
, 
, 
.
IN USE/CHARGE Indicator
When the handset is in the base cradle, the IN USE/CHARGE indicator increases intensity with each ring of the incoming call. When the handset is not in the base, the IN USE/CHARGE indicator flashes steadily. After the call is answered, the IN USE/CHARGE indicator will remain lit until the end of the call.
Memory Card
There is a memory card with an erasable surface located on the tele- phone base unit to record the names or telephone numbers for the first 10 (locations
NOTE: The 9110 has a total of 21 memory locations (number locations
5 |
Programming a Pause Into a Memory
Dial Phone Number
If your phone is connected to a PBX (switchboard) you may have to dial a special number (e.g., 9) to get an outside line. When programming a number into memory, store the access number and a pause into the number sequence. The pause will allow the switchboard enough time to give you an outside line dial tone.
To insert a pause in a stored number,
press the 
key. This inserts a 
key two or more times. Each time you hear another beep, it makes the pause 2 seconds longer.
For example, to store 9, PAUSE,
555-1234: Press 
, 
.
Then press 
.
NOTE: Each pause you program is counted as a digit. You can program up to 20 digits in each memory location.
Changing or Replacing a
Stored Number
You can change or replace a stored number by storing a new number in its place.
Spare Battery Charger
(under Memory Card)
Memory Card
Base Antenna
POWER indicator goes on
when the base power
adapter is plugged into an
electrical outlet.
IN USE/CHARGE
description above
SPARE BATTERY indica- tor goes on when you are charging a spare battery.
Page/Handset Locator
