Installation
Note: The extractor hood is intended to hang from a horizontal ceiling capable of supporting the weight of the hood. (Approximately 40Kg.)
Step 1
•Carefully unpack the extractor hood, the component parts and remove the grease filter. See page 8.
•With the assistance of a qualified installer, mount the top extension adaptor to the ceiling directly above the cooking surface using the 4 x M6 bolts as supplied.
•Where applicable, cut a hole in the ceiling to accept the power cord, the fitted plug and an outlet pipe.
Step 2
•Fit and secure the angular mounting structures into the four recesses on the extractor hood using the 12 x M6 bolts and washers supplied.
Step 3
•Slide the lower chimney duct onto the extractor hood.
•Slide the top chimney (the one with the slotted vents) into the lower chimney duct.
Step 4
•Lift the extractor hood assembly into the top extension adaptor. Adjust to a suitable height
(A minimum clearance height of 650 mm is required when installed above a built in electric hob or 700 mm when installed above a built in gas hob).
•Ensure that the extractor hood is level before tightening the 4 x M8 clamping bolts which hold the hood in place.
•Connect the outlet pipe, if required, and insert the fitted plug into a 15A earthed socket.
Step 5
•Slide the upper chimney duct into place against the ceiling.
•Fasten from the sides with 2 x 4.8 mm self tapping screws.
Step 6
•Fasten the lower chimney duct to the extractor hood from underneath.
•Refit the grease filter.
Page 7
