Defy Appliances DHD 394 Technical Specifications, Error codes, Model, Plate power rating W

Technical Specifications

Model		DHD 394
Volts		220V –240V 50Hz~
Amperes		28
Plate power rating (W)
Front cooking zone left		140, 1200
Front cooking zone	right	140, 1200
Rear cooking zone	right	180, 1800
Rear cooking zone	left	210/120, 2200/750
Total power (W)		6400
Type of switch		Electronic sensors
Width		580 mm
Depth		510 mm

Error codes

ERROR CODE	ERROR DESCRIPTION	WHAT TO DO
ER03	Continuous holding down of sensors.	CONTACT YOUR DEFY SERVICE
& permanent tone	Control unit cuts off after 10 seconds.	CENTRE AND SPECIFY THE ERROR
		CODE
	Water or a cooking utensils may be posi
	tioned over the control unit causing inter
	ference.
ER21	Overheating: The control unit switches	CONTACT YOUR DEFY SERVICE
	off in order to avoid damage to the unit	CENTRE AND SPECIFY THE ERROR
		CODE
U400	Secondary voltage of the power unit is	1 CONTACT YOUR DEFY SERVICE
	too high. Control unit switches off after	CENTRE AND SPECIFY THE ERROR
		CODE
	one second and permanent tone is emit
		2 CONTACT AN ELECTRICIAN TO
	ted.	CHECK THE MAINS POWER SUPPLY
ER22	Touch pad evaluation is defective. Con	CONTACT YOUR DEFY SERVICE
	trol unit switches off after 3.5—7 se	CENTRE AND SPECIFY THE ERROR
		CODE
	conds. Short circuit or there is a problem
	with the sensor evaluation range
ER36	NTC value is not within its specification.	CONTACT YOUR DEFY SERVICE
	(Value < 200mV or > 4.9V; Control unit	CENTRE AND SPECIFY THE ERROR
		CODE
	cuts off. Short circuit or cut off at NTC
ER20	Flash failure. Micro controller faulty	CONTACT YOUR DEFY SERVICE
		CENTRE AND SPECIFY THE ERROR
		CODE
ER40	Secondary operational voltage is too	CONTACT YOUR DEFY SERVICE
	low. (1.8V <U Power fail< 2.9V) Primary	CENTRE AND SPECIFY THE ERROR
	PTC too hot	CODE

PAGE 9 OF 12