Delkin Devices 4 manual Driver Installation Procedure

USB SmartMedia Card Reader DDREADER-04

Note: OSR 2.0 is also called version B (4.00.950B), but it does not support the eFilm Reader-4. The 1214 version number must be present for your system to use the Reader-4. If your version is lower (older) than these, you will need to upgrade to Windows 98 for your computer to recognize the eFilm Reader-4.

Driver Installation Procedure

1.Start Windows and close any other applications during installation.

2.Insert the Delkin Devices driver CD-ROM. If the CD does not start automatically, double click on the CD-ROM drive in My Computer. The CD will open in a driver insallation application. (See Figure 1)

3.Click Reader-4from the list of products on the left. There is a single installer for all Windows operating systems.

4.Verify that your product matches the one pictured on the screen.

5.Click the button labeled Click Here to Begin Installation and follow the on-screen instructions. For best results,allow the drivers to be installed into the default locations.

6.When the Setup Complete screen

appears, click the Finish button.

7.Connect the Reader-4 to the USB port or hub.

8.You may now insert a SmartMedia Card and access it like other drives by clicking the Removable Disk

drive icon in My Computer. Figure 1: Windows Installation Program

Driver Software Installation Procedure for Apple Macintosh

Before connecting the eFilm Reader-4, you must install the device drivers located on the accompanying CD-ROM. To avoid compatibility issues, install only the Reader-4 driver. Slot or front loading CD-ROMs may not function correctly with a 3” CD disk. For these systems it is recommended that you download the driver from www.delkin.com

Prior to any software installation always ensure you have backed up your hard driveand prepared a recovery disk.

1.	Insert the Driver CD-ROM, then double-
	click on the CD icon when it appears.
2.	Select eFilm Reader-4from the product
	list. (See Figure 2)
3.	Click the button labeled Install and follow
	the on-screen instructions. Select Restart	Figure 2: Macintosh Installation Program
	Computer after installation is complete.

Page 2 Delkin Devices User’s Manual