Back to Contents Page
USB/Audio Board
Dell™ Studio 1535/1536/1537 Service Manual
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer.
Removing the USB/Audio Board
1.Follow the procedures in Before You Begin.
2.Remove the optical drive (see Removing the Optical Drive).
3.Disconnect the two cables of the USB/Audio board from the connectors on the system board.
4.Remove the adhesive tapes from the cables securing it to the system board.
5.Remove the screw securing the USB/Audio board to the computer base cover and remove the board.
1 | USB board | 2 | USB/Audio cables |
|
|
|
|
Replacing the USB/Audio Board
1.Connect the USB/Audio board cables to the system board connectors.
2.Place the USB/Audio board in position and replace and tighten the screw to secure the board.
3.Replace the optical drive (see Replacing the Optical Drive).
