IDE Primary Master Submenu
Option | Function |
|
|
IDE HDD | Press <Enter> to start |
|
|
IDE Primary Master | Specifies the type of hard drive. Settings for this option are Auto (default), None, and Manual. |
Capacity | Displays the maximum capacity of the primary IDE device. |
|
|
Cylinder, Head, Precoup, Landing Zone, | Displays each setting of the primary IDE device. |
Sector |
|
|
|
Access Mode | Sets the access mode of the primary IDE device. The options are Auto (default), CHS, LBA, and Large. |
|
|
PIO Mode | Sets the PIO mode of the primary IDE device. The options are Auto (default), Mode 0, Mode 1, Mode 2, Mode 3, |
| and Mode 4. |
|
|
UDMA Mode | Sets the ultra DMA setting of the primary IDE device as either Auto (default) or Disabled. |
|
|
Diskette Configuration Submenu
Option | Function |
|
|
Diskette Controller | Configures the floppy drive interface. Options are Enabled (default) and Disabled. |
|
|
Drive A: | Selects the floppy drive type as 1.44M, 3.5 in (default); None; 360K, 5.25 in; 1.2M, 5.25 in; 720K, 3.5 in; or 2.88M, 3.5 in. |
|
|
Floppy 3 Mode | Selects Floppy 3 mode support for the floppy drive. Options are Disabled (default) and Drive A. |
Support |
|
|
|
Diskette Write | Protects a floppy disk from being written to when set to Enabled. When this option is set to Disabled (default), the floppy disk is not |
Protect | protected unless the |
|
|