Install the Battery Backup Card, Continued
Attach Module to PowerEdge Controller Fasten the Battery Backup Module to the PowerEdge RAID controller using the q” screw and nylon washer supplied with the Battery Backup Module. First, insert the screw through the nylon washer. Then insert the screw through the hole on the PowerEdge controller, starting at the back of the PowerEdge controller. Next, tighten the screw into the threaded standoff on the Battery Backup Module. The screw must not be as tight as you can make it. Tighten the screw so that it is flush with the back of the PowerEdge controller, but not so tight that it cannot be turned anymore.
Cont’d
Chapter 1 Installing the Battery Pack | 5 |
