Back to Contents Page
Display Assembly and Display Latch
Dell™ Latitude™ C400 Service Manual
Removing the Display Assembly
Replacing the Display Latch

Removing the Display Assembly

NOTICE: You must remove the display assembly before you remove the palm rest.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed
batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on
the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.
1. Remove the battery.
2. Remove the hard drive.
3. Remove the center cover.
4. Close the display.
5. Turn the computer over and remove the two M2.5 x 6-mm screws at the bottom back corners of the computer.

Display Screws

1M2.5 x 6-mm screws (2)
6. Turn the computer right-side up and open the display 180 degrees.