2.Install the three screws to secure the processor module to the system board.
3.Place a new processor
Always use a new clip. Do not reuse an old clip.
7KHUPDO&RROLQJ$VVHPEO\
Before you install the TCA in the computer, you must attach Kapton tape to the left tab at the front of the TCA (see Figure 2). The tape must be attached so that the entire length of the tab is covered.
thermal transfer pad
TCA
tape
tab
)LJXUH.DSWRQ7DSH
To apply the tape and install the TCA, perform the following steps:
1.Place the tape along the length of the back of the tab.
No less than 1/16 inch (0.16 cm) of tape should extend up from the bottom edge of the tab, as shown in Figure 3.