GETTING STARTED
Package contents
Before beginning, ensure that the carton contains the following items:
1. LCD Monitor
2. Monitor Base and Neck
(the shape of base may vary according to the monitor model)
3.Power Cord (plug may vary according to the electrical standards for your area)
4.Analog Signal Cable
5.
6 .Quick Installation Guide
Monitor installation
1.Setting up the monitor
1.1 Take out the monitor, stand and monitor base from the package. 1.2 Place the monitor base on the desk and then slide the neck
into the slots of base. (Make sure the direction of the neck is correct.)
1.3 Hold the monitor and then slide the monitor into the neck. (Make sure the direction of the neck is correct)
2.Connecting signal cable
2.1Switch off your computer
2.2Connect the signal cable to the
the monitor and tighten the connector screws
2.3 Connect the other end of signal cable to the computer's VGA port and tighten the connector screws.
2.4 Note: Ensure the display setting does not exceed
1366 X 768 @ 60Hz.
3.Connecting power
Connect one end of the power cable to the monitor and the other end to a power outlet.
4.Switching on
Switch on your computer.
You should now be able to see the picture. If not, see the | POWER | |
|
| |
troubleshooting section of this guide. |
|
|
- 2 -