Dell E1913S, E2213C appendix Connecting Your Monitor, Connecting the Blue VGA Cable

Dell E1913S/E1913/E2213 Monitor User's Guide

After placing the monitor panel on a soft cloth or cushion, complete the following steps to remove the monitor stand:

1.Use a long screwdriver to push the release latch located in a hole just above the monitor stand.

2.Once the latch is released, remove the monitor stand away from the monitor.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.

To connect your monitor to the computer:

1.Turn off your computer and disconnect the power cable.

2.Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.

Connecting the Blue VGA Cable

file:///K/Dell/E1913/Dell%20E1913(S)%20E2213%20E-DOC%20Source/en/ug/setup.htm[2012-3-19 16:22:02]