Dell E248WFP appendix Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Models: E248WFP

1 30
Download 30 pages 51.06 Kb
Page 25
Image 25
Setting Up the Monitor

Back to Contents Page

Setting Up the Monitor

Dell™ E248WFP Flat Panel Monitor

Attaching the Stand

Connecting the Monitor

Organizing Your Cables

Attaching the Soundbar (optional)

Removing the Stand

Attaching the Stand

NOTE: The stand is detached when the monitor is shipped from the factory.

Place the stand on a flat surface and follow these steps to attach the monitor stand:

1.Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.

2.Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.

Connecting Your Monitor

Attaching the Stand CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.

To connect your monitor to the computer perform the following steps/instructions:

Turn off your computer and disconnect the power cable.

Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.

Connecting the white DVI cable

Page 25
Image 25
Dell appendix Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor, Dell E248WFP Flat Panel Monitor