Dell™ PowerEdge™ M710 Technical Guidebook
8
featuRe icOn DescRiPtiOn
Blade Power
Indicator
Off – Power is not available to the blade, the blade is in standby
mode, the blade is not turned on, or the blade is installed
incorrectly. For detailed information on installing a blade, see
"Installing a Blade."
Green increasing from low brightness to full brightness – Blade
power on request is pending.
Green on – The blade is turned on.
Blade Status/
Identication
Indicator
Off – The blade power is off.
Blue – Normal operating state.
Blue Blinking – The blade is being remotely identied via the CMC.
Amber Blinking – Blade has either detected an internal error, or
the installed mezzanine card(s) does not match the I/O modules
installed in the M1000e enclosure. Check the CMC for an I/O
conguration error message and correct the error.
Blade Power
Button N/A
Turns blade power off and on.
• If you turn off the blade using the power button and the blade
is running an ACPI-compliant operating system, the blade can
perform an orderly shutdown before the power is turned off.
• If the blade is not running an ACPI-compliant operating system,
power is turned off immediately after the power button is pressed.
• Press and hold the button to turn off the blade immediately.
The blade power button is enabled by default by the System Setup
program. (If the power button option is disabled, you can only use
the power button to turn on the blade. The blade can then only be
shut down using system management software.)
USB Connector Connects external USB 2.0 devices to the blade.