Dell N4020, N4030 manual Back to Contents

NOTE: If a new processor module is installed, you will receive a new thermal-cooling assembly, which will include an affixed thermal pad, or you will receive a new thermal pad along with documentation to illustrate proper installation.

1.Follow the instructions in Before You Begin.

2.Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then place the processor module.

NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.

When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the others, the module is not seated properly.

CAUTION: To avoid damage to the processor module, hold the screwdriver perpendicular to the processor module when turning the cam screw.

3.Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.

4.Replace the thermal cooling assembly (see Replacing the Thermal Cooling Assembly).

Back to Contents Page