Error Message | Description |
Diskette subsystem reset failed | The floppy drive controller may be faulty. |
Gate A20 failure | One or more memory modules may be faulty or improperly seated. Reinstall |
| the memory modules and, if necessary, replace them. |
General failure | The operating system is unable to carry out the command. This message is |
| usually followed by specific |
| Take the appropriate action to resolve the problem. |
The hard drive failed initialization. | |
The hard drive failed initialization. | |
The hard drive failed initialization. | |
The hard drive failed initialization. | |
Invalid configuration information- | The computer configuration information does not match the hardware |
please run SETUP program | configuration. |
Invalid Memory configuration, please | DIMM1 slot does not recognize a memory module. The module should be re- |
populate DIMM1 | seated or installed. |
Keyboard failure | A cable or connector may be loose, or the keyboard or keyboard/mouse |
| controller may be faulty. |
Memory address line failure at | A memory module may be faulty or improperly seated. Reinstall the memory |
address, read value expecting value | modules and, if necessary, replace them. |
Memory allocation error | The software you are attempting to run is conflicting with the operating |
| system, another program, or a utility. |
Memory data line failure at address, read value expecting value
Memory double word logic failure at address, read value expecting value
Memory odd/even logic failure at address, read value expecting value
Memory write/read failure at address, read value expecting value
Memory size in CMOS invalid
A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them.
A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them.
A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them
A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them.
The amount of memory recorded in the computer configuration information does not match the memory installed in the computer.
Memory tests terminated by keystroke | A keystroke interrupted the memory test. |
No boot device available | The computer cannot find the floppy disk or hard drive. |
No boot sector on | The computer configuration information in System Setup may be incorrect. |
No timer tick interrupt | A chip on the system board might be malfunctioning. |
The floppy disk in drive A does not have a bootable operating system installed | |
| on it. Either replace the floppy disk with one that has a bootable operating |
| system, or remove the floppy disk from drive A and restart the computer. |
47