Dell W-3000 manual Installation in a Telecom Rack, For a Telecom Rack, For a Server Rack

Chapter 2

Installing the W-3000 Series

Controllers

The following tools and equipment are required for installing the Dell PowerConnect W-3000 Series Controllers:

zRack Mount Bracket (x2, not used for tabletop installation)

zSuitable Screwdrivers

zAC Power Cord (country-specific)

Caution: Installation and service of Dell Networks products should be performed by Professional Installers. Additional antenna and transmit power information for Professional Installers can be found at https://support.dell.com.

For a Telecom Rack:

z6-32 x 1/4” Phillips Head Screws (6x, included)

z12-24 x 5/8” Phillips Head Screws (4x, included)

For a Server Rack:

z6-32 x 1/4” Phillips Head Screws (6x, included)

zM6 x 20mm Phillips Head Screws (4x, included)

zM6 Cage Nuts (4x, inluded) or M6 Cage Clips (4x, inluded)

Installation in a Telecom Rack

To install the W-3000 Series Controllers into a 19-inch (48.26 cm) rack system:

1.Place a rack mount bracket over the mounting holes on one side of the controller (see Figure 1).

2.Secure the bracket to the controller using three 6-32 x 1/4” phillips flat head screws and a suitable screwdriver.

3.Repeat these steps on the opposite side of the controller.

Dell PowerConnect W-3000 Series Controller Installation Guide Installing the W-3000 Series Controllers 13