A-14 Dell Dimension XPS H233 System Reference Guide
WARNING:Could not con-
figure
Plug and Play Card Name.
WARNING: Could not con-
figure PCI device,
ID=
DeviceID.
Failed to configure
Number of
Total Count Plug and Play ISA
devices. Use your sys-
tem’s configuration
utility to resolve con-
flicts. Press any key
to continue.
The card(s) mentioned are not
fully configured due to
resource conflicts.
If you do not know the allowable resource
values for your Plug and Play or PCI expansion
card, use the following procedure to locate and
resolve the resource conflict. For instructions on
any of these options, see the “Configuring
Expansion Cards” section in the online System
User’s Guide.
1. Remove all card configurations from the
ISA Configuration Utility.
For instructions, see “Removing a Card.”
2. Insert your backup copy of the ISA Con-
figuration Utility diskette into drive A, and
reboot your system.
The ISA Configuration Utility should auto-
matically configure your Plug and Play or
PCI expansion card.
3. Add the ISA cards back into the ISA
Configuration Utility, resolving any
resource conflicts as they arise.
See “Adding a Listed Card.”
If your Plug and Play or PCI expansion card is
not automatically configured when you reboot
the system with all other cards removed, you
should contact the manufacturer of the card or
see the chapter titled “Getting Help” in your
Diagnostics and Troubleshooting Guide.
Table A-4. Configuration Manager Messages (continued)
Message Probable Cause Corrective Action
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.