Dell XPS H233, XPS H266 manual Table A-5. Peripheral Configuration Submenu Categories

Table A-5. Peripheral Configuration Submenu

Categories (continued)

Category	Function
Parallel Port Interface	Configures the built-in parallel port on the
	system board. Set this category to Auto Con-
	figured (the default) or to Disabled, or select a
	specific port designation, I/O address, and IRQ
	line for the port. The available port designa-
	tions are LPT1, LPT2, and LPT3; available I/O
	addresses are 378h, 278h, and 3BCh; and
	available interrupts are IRQ7 and IRQ5.
Parallel Port Type	Controls the mode used by the system’s built-
	in parallel port. Options for this category are:
	• Compatible — For a unidirectional device
	• Bi-directional — For a bidirectional device
	• ECP — For an ECP device
	• EPP — For an EPP device (not supported)
USB Interface	Determines whether the USB connectors are
	Enabled (the default) or Disabled. If this cate-
	gory is set to Enabled, the system dynamically
	allocates an IRQ for the USB connectors
	according to the PCI specification.
Audio Interface	Determines whether the integrated audio con-
	troller is Enabled (the default) or Disabled. Set
	this category to Disabled to use a sound
	expansion card instead of the integrated audio
	controller.
Primary PCI IDE Status	Indicates whether the primary EIDE interface
	is enabled or disabled.
Secondary PCI IDE Status	Indicates whether the secondary EIDE inter-
	face is enabled or disabled.
Floppy Status	Indicates whether the diskette/tape drive inter-
	face is enabled or disabled.
Serial Port 1 Status	Indicates whether the serial port is enabled or
	disabled; displays configuration settings if
	enabled.
Parallel Port Status	Indicates whether the parallel port is enabled or
	disabled; displays configuration settings if
	enabled.

System Setup Program A-9