Back to Contents Page
Power Connector
Dell™Latitude™Z600ServiceManual

Removing the Power Connector

1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the hinge covers from the computer.
4. Remove the access panel from the computer.
5. Remove the screw that secures the power connector to the computer.
6. Remove the power connector cover from the computer hinge.
7. Disconnect the power connector cable from the system board.
8. Remove the power connector from the computer.

Replacing the Display Assembly

To replace the display assembly, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.