GB
D i s p o s i n g o f t h e c o l l e c t e d
w at e r
A)Empty the tank manually.
When the tank is full, remove and empty it into a large sink or tub (fig.1).
When finished, replace it properly.
NOTE: The tank must be positioned properly making sure slots on back of tank are positio- ned correctly.
For the electronic model, if you hear the con- tinual sound of the buzzer, it means the tank is not in the proper position.
For the mechanical model, after removing the tank, you must first wait 3 minutes to repla- ce the tank.
B)Continuous draining.
Condensed water can be drained via a hose |
| |
connected to an outlet at the rear of the tank: |
| |
1. | remove the water tank. |
|
2. | Using a 5 mm drill bit, drill a hole in the rear of |
|
| the tank along the torus like in figure 2. |
|
3. | connect a hose to the hose connector. Be |
|
| sure the hose does not kink or bend. |
|
| Make sure that the hose is not higher than the |
|
| hose connection (see figure 3). |
|
| NOTE: If you do not want to use the hose, you | Drill |
| can plug the hole with the rubber stopper | |
|
| |
| accessory. |
|
fig. 1
fig. 2
fig. 3
Hose
Drain
8
