LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE SAFETY DEVICE (Dual Burners)
In order to light the burner, you must:
1 – Push and turn the knob in an 
position (maximum rate of inner crown); push in and hold the knob until the flame has been lit.
The sparks produced by the lighter situated inside the relative burner will light the flame.
In the event that the local gas supply conditions makes it difficult to light the burn-
er in | position, try again with the knob in | position. |
If there is no mains electrical supply connection, bring a lighted match close to the burner.
2 – Wait for about ten seconds after the gas burner has been lit before letting go the knob (safety device activation delay).
2 – Adjust the gas valve to the desired position.
If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.
To 
), wait for at least 1 minute and then repeat the lighting procedure.
N.B. When the range is not being used, set the gas knobs to their 
positions and also close the gas
CAUTION!
The range becomes very hot during operation. Keep children well out of reach.
11
