EC190/200 GB
HOW TO MAKE ESPRESSO COFFEE
FILLING THE WATER TANK
Remove the water tank lid (fig. 2) and then take out the tank by pulling upwards (fig. 3).
Fill the tank with fresh clean water taking care not to exceed the MAX level (fig. 4).
Replace the tank, pressing lightly to open the valve located on the bottom of the tank.
More simply, the tank can also be filled without removing it, pouring the water directly from a jug. IMPORTANT: It is normal for there to be water in the space under the tank. This should therefore be dried regularly with a clean sponge.
Note: Never use the appliance without water in the tank and always remember to top up when the level drops to about an inch from the bottom.
PREHEATING THE COFFEE UNIT
To obtain espresso coffee at the ideal temperature, it is recommended that the coffee machine be preheated. Turn the selector knob to the
position (fig. 5) before making coffee, making sure the filter holder is attached to the appliance (check that the steam knob is closed). To attach the filter holder, position it under the boiler outlet with the handle towards the left (see fig. 6), push it upwards and at the same time rotate the handle towards the right. Rotate firmly. Wait until the preheating process is complete, and then make coffee as described in the following chapter.
Alternatively, preheating can be achieved more rapidly proceeding as follows:
1.Turn the appliance on by rotating the selector knob to
the
position (fig. 5) and attach the filter holder to the appliance without adding ground coffee.
2.Place a cup under the filter holder. Use the same cup as will be used to prepare the coffee in order to preheat it.
3.Wait for the OK indicator light to come on (fig. 7),
then immediately rotate the selector knob to the 
position (fig. 8), run the water off until the OK indicator light goes out, then interrupt delivery by
rotating the selector knob to the | position (fig. 5). |
4.Empty the cup. Wait until the OK indicator light comes on again then repeat the same operation.
HOW TO PREPARE ESPRESSO COFFEE USING THE FILTER FOR GROUND COFFEE
1.After preheating the appliance as described above, place the ground coffee filter in the filter holder, making sure the projection is correctly inserted in the slot as shown in fig. 9. For appliances with two filters, use the smallest for one coffee and the largest
for two coffees.
2.To make a single coffee only, place one level measure of ground coffee, about 7 grams, in the filter (fig. 10). To prepare two coffees, place two loosely filled measures of ground coffee (about 6+6 g) in the filter.
Fill the filter a little at a time to prevent the ground
coffee from overflowing.
IMPORTANT: for correct operation, before adding the ground coffee to the filter, clean the filter from residues of ground coffee from the previous infusion.
3.Distribute the ground coffee evenly and press lightly with the tamper (fig. 11). Note: Correct pressing of the ground coffee is essential to obtain a good espresso. If pressing is excessive, coffee delivery will be slow and the froth will be dark. If pressing is too light, coffee delivery will be too rapid and the froth will be skimpy and light colored.
4.Remove any excess coffee from the rim of the filter holder and attach the filter holder to the appliance. Rotate firmly (fig. 6) to avoid leaks of water.
5.Place the cup or cups (ideally preheated by rinsing with a little hot water) under the filter holder spouts (fig. 12).
6.Make sure the OK light (fig. 7) is on (if off, wait until
it comes on), then turn the knob to the 
position (fig. 8) until the required quantity is obtained. To
interrupt, place the selector back in the 
position (fig. 5).
7.To remove the filter holder, rotate the handle from right to left.
IMPORTANT: to avoid splashes, never remove the filter holder while the appliance is delivering coffee.
8.To eliminate the used coffee grounds, block the filter in place using the lever incorporated in the handle and empty the coffee by turning the filter holder upside down and tapping (fig. 13).
9.To turn the appliance off, rotate the selector knob to
the "O" position (fig. 14).
IMPORTANT: the first time the appliance is used, all accessories must be washed thoroughly by making at least five coffees without using ground coffee.
8
