TURNING THE APPLIANCE ON
N.B.! Before turning the appliance on, make sure the main switch is in the I position (fig. 30). Each time the appliance is turned on, it performs an automatic preheat and rinse cycle which can- not be interrupted.
The appliance is ready for use only after comple- tion of this cycle.
Danger of burns! During rinsing, a little hot water is run off from the coffee spouts. Avoid contact with splashes of water.
•To turn the appliance on, press the 
button
(fig. 4). The message "Heating Up... Please Wait" is displayed.
After heating, the message "RINSING" is dis- played. While the boiler is heating, the appliance also heats the internal circuits by circulating hot water.
The appliance is at temperature when the mes- sage "READY Standard Taste" is displayed.
TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs an automatic rinse cycle which cannot be inter- rupted.
Danger of burns! During rinsing, a little
hot water is run off from the coffee spouts. Avoid contact with splashes of water.
To turn the appliance off, press the 
button (fig. 4). The appliance performs the rinse cycle then goes off.
N.B.! If the appliance is not used for an extended period, place the main switch in the 0 position (fig. 31).
CHANGING THE MENU
SETTINGS
Setting the clock
1.Press the P button to enter the menu;
2.Turn the selection knob until "Adjust Time" is displayed;
3. | Press the |
|
|
|
| button; | EN |
4. | Turn the selection knob to change the hours; | ||||||
5.Press the 
button to confirm (or the 
button to cancel the operation);
6.Turn the selection knob to change the min- utes;
7.Press the 
button to confirm (or the
button to cancel the operation);
8. Press the | button to exit the menu. |
Setting the language
1.Press the P button to enter the menu;
2.Turn the selection knob until "Set Language" is displayed;
3.Press the 
button;
4.Turn the selection knob until the required lan- guage is displayed;
5.Press the 
button to confirm (or the
button to cancel the operation);
6. Press the
button to exit the menu.
Setting automatic start up time
You can set the
1.Press the P button to enter the menu;
2.Turn the selection knob until
3.Press the 
button;
4.Turn the selection knob to change the hours;
5.Press the 
button to confirm (or the
button to cancel the operation);
6.Turn the selection knob to change the min- utes;
7.Press the 
button to confirm (or the 
button to cancel the operation);
8.Press the
button to exit the menu. After confirming the time, the red AUTO light on the display comes on indicating that the function is active.
To deactivate the function, select
button.
The AUTO icon on the display goes off.
NB! To activate this function, the time must be set.
11
