DeLonghi ESAM5500.N manual Descaling, Setting the temperature, Auto-Off, Setting water hardness

Descaling

1.Press the P button to enter the menu;

2.Turn the selection knob until "Descaling" is displayed;

3.	Press the			button;
4.	The message		"Confirm?" is displayed.
5.	Press the			button to confirm (or the
	button	to cancel the operation);

6.Carry out descaling as described in the sec- tion "Descaling" on page 19.

Setting the temperature

1.Press the P button to enter the menu;

2.Turn the selection knob until "Set Temperature" is displayed;

3.Press the button;

4.Turn the selection knob until the required tem- perature (high, medium, low) is displayed;

5.Press the button to confirm (or the

button to cancel the operation);

6. Press the button to exit the menu.

Auto-Off

1.Press the P button to enter the menu;

2.Turn the selection knob until "Auto-Off" is dis- played;

3.Press the button;

4.Turn the selection knob until the required number of hours of operation (1, 2 or 3) is displayed;

5.Press the button to confirm (or the

	button to cancel the operation);
6. Press the	button to exit the menu.

Setting water hardness

1.Press the P button to enter the menu;

2.Turn the selection knob until "Water Hardness" is displayed;

3.Press the button;

4.Turn the selection knob until the water hard- ness measured using the indicator strip is dis-

	played (see paragraph "Measuring water hard-
	ness" - page 19);
5.	Press the	button to confirm (or the
	button to cancel the operation);
6.	Press the	button to exit the menu.

Resetting factory default values (reset)

This function resets the entire menu with the default values (except the language, which remains as set).

1.Press the P button to enter the menu;

2.Turn the selection knob until "Default Values" is displayed;

3.Press the button;

4.The message "Confirm?" is displayed.

5.Press the button to confirm and exit

(or the	button to cancel the opera-
tion);

Installing the filter

Certain models are provided with a water softener filter (alternatively it can be pur- chased separately from an authorized Customer Service Center).

To install the filter, proceed as follows:

1.Insert the filter in the water tank as far as it will go (see figure

alongside).

When you install the filter, you must notify the appliance of its presence.

2. Press the P button to enter the menu;

3.Turn the selection knob until "Install Filter" is displayed;

4.Press the button;

5.The message "Confirm?" is displayed.

6.Press the button to confirm (an aster- isk appears at the top right of the display);

7.Press the button to exit the menu.

Replacing the filter ("Reset water filter")

When the red light comes on, the filter must be replaced:

1.Extract the exhausted filter and replace with a new one;

2.Press the P button to enter the menu;

3.Turn the selection knob until "Reset Water Filter" is displayed;

4.Press the button;

5.The message "Confirm?" is now displayed.

6.Press the button to confirm (or the button to cancel the operation);

7.Press the button to exit the menu.

12