-To set the program B press “Timer button B” and follow the same procedure as described for the program A.
-Use the “ +” or “
ture, as described above.
-When set in this way the heater will automatically switch on at the set time for the designated time period and automatically maintain the
preset comfort temperature.
To cancel a preset program, press the timer button A hour button until the display shows
TIMER OVERRIDE
To operate the appliance without using the programs (timer), press the “ON MODE” button (Fig.2). The yellow lamp “ “ will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does not switch on. The display shows the blinking numbers. To switch it on, repeat the above described ope- rations.
Remote Control
The appliance can be completely controlled with the remote control. Two AAA 1.5V batteries are required (not included):
•remove the cover located on the back side of the remote control;
•insert the two AAA 1.5V batteries positioning them correctly (see the instructions in the batteries compartment);
•replace the cover.
+
-
Remote Control Operation
-When you press the frost protection push button, the radiator will set the temperature to 42°F (5°C) and will switch on automatically only if the room temperature falls below 42°F (5°C), thereby preventing freezing, at minimum energy consumption.
The “ “ light on the control panel will flash.
-Press the increase/decrease temperature button
-The “Off” button switches off the appliance.
Every time you press a button, the appliance will confirm the selection with a “beep” and the pilot light on the remote control will illuminate.
6