21 | 20 | 19 |
| ||
|
| 16 |
|
| pointer |
Fig.2 |
|
|
operating time | ||
21 | 20 | 19 |
| ||
|
| 16 |
fig.3 |
|
|
Frost protection function
With the thermostat slider in the minimum position and a power selected, the unit maintains the room at a temperature of about 5˚C, preventing freezing with minimum energy consumption.
Models with 24-hour timer
Using the timer
If you wish to use the timer, position the switch in the middle posi-
tion (Fig. 4).
Setting the correct time
Check the time on your watch. If for example it is 4.00 pm. (16.00), turn the dial in a clockwise direction until the number 16 is lined up with the triangular pointer (fig.2).
N.B.: Never turn the dial in an
The timer is in effect an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnect- ed or there is a power failure, the clock must be
To program the timer
1)Set the operating times by pushing in with your thumbnail to the outer rim, the notches on the dial corresponding to the period required (fig.3) (each notch represents 15 mins.)
2)Make sure that the timer indicates the correct time (see instructions on setting the correct time).
3)Turn the radiatior on and set it to the heat setting and temperature level on the thermostat as required.
Once programmed in this way, the appliance will repeat the pre- established program every day, if the selector is in the position.
Timer override
If you wish to override the timer settings, push the timer switch to position 1 (fig.4) manual (timer override).To return to timed oper-
ation push the switch back to the middle position (fig.4).
0 Heater off
Timer operation
I Manual (timer override)
fig.4
NOTE: if the timer switch is at the 0 position (fig.4), the heater is off and will not operate).
Dragon HM3 | 3 |
|