DeLonghi PAC60 manual Turning on and setting the timer, Electrical Connection, Programmed Mode

Turning on and setting the timer

ELECTRICAL CONNECTION

Before plugging in check that:

•the mains supply corresponds to the power supply shown on the rating plate;

•the socket and the mains lead correspond to the power requirements of the applian- ce;

•the socket is suited to the plug, otherwise have the socket replaced;

•the socket is properly grounded.

The manufactures cannot be held responsi- ble for any damages due to failure in fol- lowing normal safety procedures.

Replacement of the power cable must be carried out by qualified personnel.

PROGRAMMED MODE

1)Set the operating times by pushing out the notches on the dial corresponding to the period required (each notch represents 15 mins.)

2)Press the TIMER key 11 , the signal light

13will come ON.

3)Make sure that the timer indicates the cor- rect time (see instructions on setting).

operating time

21 20 19

16

SETTING THE TIMER

The programmer/timer 12 , like all clocks, must be set to the exact time. If for example it is 4.00 pm. (16.00), turn the dial in a clockwi- se direction (following the direction of the arrow) until the number 16 is lined up with the triangular pointer (the arrows indicates 4:00 P.M. approximately ).

21 20 19

16

pointer

N.B.: Never turn the dial in an anti-clockwise direction!

The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the programmer stops (the clock is then “slow”) and must be re-set.

4)Select the desired function as shown in the chart overleaf.

N.B.: To override the programmed operating

times, simply press the ON/OFF key 11 (the timer signal lamp ON will go out)

9