S e l e c t i n g f u n c t i o n s
AIR CONDITIONING FUNCTIONS
To turn the unit on in air conditioning mode, proceed as follows:
1. Press the | button | 10 | (the signal light “I” |
9will come on).
2.Rotate the function selector 18 dial anti- clockwise:
•Place the large star symbol 
in line with the reference mark to operate the unit in air conditioning mode at maximum fan speed (the signal light 21 will come on, and then, after 3 minutes the signal light 14 will come on ).
•Place the small star symbol 
in line with the reference mark to operate the unit in air conditioning mode at minimum fan
speed (the signal light 21 will come on, and then, after 3 minutes the signal light
15will come on ).
3.Now set the required temperature by rota- ting the room thermostat dial 19 .
Note
The temperature is not expressed in degrees. We recommend that you turn the thermostat dial to the maximum position. When the desi- red room temperature has been reached, slowly turn the thermostat in a clockwise direction until it arrives at the position where a click can be heard. The signal lights 21 and
14(or 15 ) will turn off.
The temperature selected in this way will automatically be regulated and maintained, and save energy. When regulating the ther- mostat, the air conditioning function is tem- porarily interrupted and the unit continues to operate in fan only mode. In this way, the appliance keeps the air temperature within the room even.
Delay on Start Up
1.A special safety device will delay the start of air conditionig by approximately 3 to 5 minutes when switching between func- tions or on initial start up.
2.You may also experience a slight delay between changing from one function to another.
10
TURBO POWER
The Turbo Power mode was designed to pro- vide the appliance with a greater cooling potential. This is particularly useful when you want to bring the temperature of a very warm room quickly down to a more comfor- table level. In this case:
Make sure that the tank is full of water (see page 22);
Make sure that the function selector switch
18is in the large crystal position.
Press the Turbo Power button 20 .
After reaching the desired temperature, you can release the Turbo Power button and reposition the selector switch to the small cry- stal. Doing so will make the operation quiter.
VENTILATION/FILTRATION
Rotate the function selector 18 clockwise.
•Press the 
button 10 (the signal light “I” 9 will come on).
•Place the large symbol 
(or the symbol
) in line with the reference mark to ope- rate the unit at maximum fan speed. (the
signal light 17 will come on).
•Place the small symbol
(or the symbol 
) in line with the reference mark to operate the unit at minimum fan speed. (the signal light 16 will come on).
PURIFICATION FILTER (Only for some models)
In addition to dust, this purification filter is able to capture even the smallest sized particles and impurities (up to 0.003 millimetres), such as cigarette smoke.
The purification filter should never be used with the dust filter, which is also included with the appliance. Therefore:
A. If you wish to use the purification filter:
Remove the purification filter from the filter housing;
Remove the aspiration grill 6 (fig. G on page 24) and the dust filter which is attached to this.
Remove the purification filter from its packa- ging.
