Wayne-Dalton 6100 Pull Handle Installation, horizontal and vertical center on the, tapping screws

6	Pull Handle Installation
Tools Needed:	On single doors, locate and mark the
Tape Measure	horizontal and vertical center on the
	bottom rail of the bottom section.
Pencil
Power Drill	Center the pull handle using the vertical
1/16” Drill Bit	and horizontal lines as reference on the
	bottom section rail as shown. Using the
	pull handle as a template, mark the two
	holes in the pull handle on the horizontal
	line of the bottom section rail. Drill a
	1/16” pilot hole, then fasten pull handles
	using (2) #10 X 5/8” pan head self
	tapping screws.
	Note: Reference illustrations for pull
	handle positions on single and double
	car garage doors. If your door came with
	two pull handles they must be installed
	as shown in the bottom illustration.

Bottom	8” max.
SECTION
LOCATE THE CENTER	bottom of the door

Bottom

SECTION

Pull Handle

(2) #10 X 5/8”

pan head self tapping screws

Pull Handle Placement reference on single wide doors

INSTALLATION

Pull Handle Placement reference on double wide doors

11

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com