Wayne-Dalton 6100 installation instructions Bottom Section, Vertical Track

10	Bottom Section
Tools Needed:	Center the bottom section in the door
Level	opening. Level section using wooden
	shims (if necessary) under the bottom
	section.

Level

BOTTOM SECTION

Wood shims

(if necessary)

11				vertical track
	Vertical Track	fLAGANGLE				BOTTOM SECTION
Tools Needed:	IMPORTANT: The tops of the
3/16” Drill Bit	vertical tracks must be level
Power Drill	from side to side. If the bottom
	section was shimmed to level it.				5/8”
7/16” Socket				roller
	The vertical track on the shimmed
Driver	side, must be raised the height of
Tape Measure	the shim.
Level	Position the left hand vertical track	VERTICAL	5/16” x			LAG
	assembly over the rollers of the bottom
Step Ladder		TRACK	1-5/8” LAG	LAG
	section. Make sure the counterbalance					SCREW
		ASSEMBLY	SCREWS	SCREW
						locations
	cable is located between the rollers			locations
	and the door jamb. Drill 3/16” pilot
	holes into the jambs for the lag	JBUS JAMB
	screws. Loosely fasten jamb brackets
		BRACKET		12r qi flagangle		15r qi flagangle
	and flagangle to the jamb using
						quick install
	5/16” x 1-5/8” lag screws. Tighten lag
		Q.I. JAMB				jamb bracket
	screw securing bottom jamb bracket to
		BRACKET
	jamb, to maintain 5/8” spacing. Hang
				LAG
	cable drum over flagangle.
				SCREW
	Repeat for the right hand side.			locations
			BOTTOM			lag
				12r & 15r Fully		screw
			SECTION
				Adjustable flagangle

14

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com