Wayne-Dalton 6100 Side Lock, Pull Rope, On Doors With Electric, Operators. Children May

�	Side Lock	1/8”
Tools Needed:	Install the side lock on the second
Power Drill	section of the door. Secure the lock
7/16” Socket	to the section with (4) 1/4”- 20 x
	11/16” self drilling screws. Square the
Driver
	lock assembly with the door section

and align with the square hole in the vertical track. The side lock should be spaced approximately 1/8” from the section edge.

IMPORTANT: side locks must be removed or made inoperative in the unlocked position if an operator is installed on the door.

NOTE: After completing this step, continue with Step 13 on page 15.

		(4) 1/4”- 20 x 11/16”
		self drilling screws
�	Pull Rope	NO. 6 SCEW EYE
Tools Needed:	WARNING
Power Drill
	DO NOT INSTALL PULL ROPES
1/8” Drill Bit
	ON DOORS WITH ELECTRIC
	OPERATORS. CHILDREN MAY	PULL ROPE
	BECOME ENTANGLED IN THE
	ROPE CAUSING SEVERE OR
	FATAL INJURY.
	Measure and mark the jamb
	approximately 48” to 50” (1220 to 1270
	mm) from floor on the right or left side
	of jamb. Drill 1/8” pilot hole for No. 6	PULL ROPE
	screw eye. Tie the pull rope to the No.
	6 screw eye and to the bottom bracket
	as shown.
		BOTTOM BRACKET
32

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com