Wayne-Dalton 6100 Installation, Attaching Quick Install Flag, Angles to Vertical Tracks

Installation

Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb with header. Side clearance, from edge of door to wall, must be a minimum of 3-1/2” (89mm) on each side.

IMPORTANT: Stainless steel or PT 2000 coated lag screws MUST be used when installing center bearing brackets, end brackets, jamb brackets, operator mounting/support brackets and disconnect brackets on treated lumber (preservative-treated). Stainless steel or pt 2000 coated lag screws are NOT necessary when installing products on untreated lumber.

NOTE: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit prior to fastening.

1	Attaching Quick Install Flag	QUICK INSTALL TAB UNLOCKED	QUICK INSTALL TAB LOCKED
	Angles to Vertical Tracks
Tools Needed:	NOTE: If you have fully adjustable
None	flagangles, skip this step and complete
	Step 2.
	Place the lower quick install tab of the
	flagangle in the quick install feature of	FLAGANGLE	FLAGANGLE
	the vertical track. Give the flagangle 1/4
	turn to lock in place. Repeat for other
	side.
	NOTE: After completing this step,
	continue with Step 3.
		VERTICAL	VERTICAL
		TRACK	TRACK
		left hand track and flagangle	right hand track and flagangle
			7

INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com