Wayne-Dalton 6100 installation instructions Top Section, Installation

15	Top Section
Tools Needed:	Place the top section in the opening.
Hammer	Temporarily secure the top section by
Step Ladder
	driving a nail in the header near the
	center of the door and bending it over
	the top section.
	Now, flip up hinge leafs, hold tight
	against section, and fasten center
	hinges first, and end hinges last. (Refer
	to Step 12).
	Position flagangle between 1-11/16”
	(43 mm) to 1-3/4” (44 mm) from the
	edge of the door; tighten the bottom
	lag screw. Flagangles must be parallel
	to the door sections. Repeat for
	opposite side.
	IMPORTANT: THE DIMENSION
	BETWEEN THE FLAGANGLES MUST BE
	DOOR WIDTH PLUS 3-3/8” (86MM) TO
	3-1/2” (89 MM) FOR SMOOTH, SAFE
	DOOR OPERATION.
	Complete the vertical track installation
	by securing the center jamb bracket(s)
	and tightening the other lag screws.
	Repeat for opposite side.

door width + 3-3/8” to 3-1/2”

NAIL

top section

1-11/16” TO 1-3/4”

top

SECTION

FLAGANGLE

INSTALLATION

17

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com