|
| |
20 | Center Bracket Bushing | |
| ||
|
| |
Tools Needed: | NOTE: If you are installing the idrive® | |
None | opener with your garage door, skip this | |
step and go to your idrive® Installation | ||
| ||
| Instructions and Owner’s Manual. After | |
| completing steps | |
| Installation Instructions and Owner’s | |
| Manual, rear supports will need to be | |
| fabricated/installed to support both | |
| horizontal tracks, see step 28. | |
| NOTE: If you are not installing the | |
| idrive® opener on your garage door, you | |
| must install the center bracket bushing | |
| assembly. Follow these instructions for | |
| ||
| Being cam shaped the center bracket | |
| bushing only fits one way. | |
| Slide the center bracket assembly | |
| towards the center of the TorqueMaster® | |
| spring tube, from the right side as shown. | |
|
|
CENTER
BRACKET
ASSEMBLY
TorqueMaster®
Spring Tube
TorqueMaster®
Spring Tube
CENTER
BRACKET
BUSHING
INSTALLATION
21 | Drum Wraps/ Cable Drums |
| Left hand drum wrap | |
|
|
| ||
| Right hand |
|
| |
Tools Needed: | IMPORTANT: RIGHT AND LEFT HAND | drum wrap |
|
|
|
|
| ||
Tape Measure |
|
|
| |
IS ALWAYS DETERMINED FROM INSIDE | Left hand |
| TorqueMaster® | |
Step Ladder | THE GARAGE LOOKING OUT. |
| ||
drum wrap |
| spring tube | ||
|
| |||
| Drum wraps are identified as right hand and left |
| Tabs | assembly |
|
|
|
| |
| hand. |
|
|
|
| Slide the left hand drum wrap over the left side |
|
|
|
| of the TorqueMaster® spring tube assembly |
|
|
|
| with the tabs facing left. Continue sliding the |
|
|
|
| left hand drum wrap towards the center of the | Winding shaft | TorqueMaster® | |
| TorqueMaster® spring tube assembly. | |||
|
| |||
|
|
| spring tube assembly | |
| Repeat for right hand side. |
|
|
|
| Shake the TorqueMaster® Plus spring tube |
|
| |
| assembly gently to extend the winding shafts out |
|
| |
|
|
|
| |
| about 5" on each side. For single spring | TorqueMaster® Plus |
|
|
| applications, there will be no left hand spring in |
|
| |
| spring tube assembly |
|
| |
| the TorqueMaster® Plus spring tube assembly. |
|
| |
|
| (cam peak straight up) |
|
|
| Lift the TorqueMaster® Plus spring tube assembly |
|
|
|
| and rest it on the top of the flagangles. |
|
|
|
| NOTE: Cable drums are marked right and left |
|
|
|
| hand. Cable drums and TorqueMaster® Plus |
|
|
|
| spring tube assembly are cam shaped to fit | Right drum |
|
|
| together only one way. |
|
| |
| Counterbalance cable |
| ||
|
|
|
21
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at