TEMPORARY INSTALLATION
Note: In both cases (permanent and temporary installations) make sure that the Pinguino is positio- ned on level ground. If necessary use the two caster stops for the front casters
This installation makes it easy to use Pinguino in any room, provided there is a window or a door: it allows you to use the Pinguino immediately.
Suction discs may be used to keep window or door closed.
Pinguino is equipped with an adjustable window bracket. If you have a sash window, place the bracket on the win- dow sill, extend the bracket fully within the window frame and lower the window onto the bracket. Insert the nozzle of the exhaust hose into the slot, then connect the hose to the air conditioner.
fig. 5 |
fig. 6 |
window |
bracket |
fig. 7 |
SET UP INSTRUCTION
For permanent installation place the Pinguino near the outlet opening in wall or window (where it is meant to be used). The diagram below shows the correct way to installl the exhaust hose.
1) Water collects at this point | 2) Bend this section |
| 3) Bend this section | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
fig. 8NOYESYES
ELECTRICAL CONNECTION
Check that the power supply voltage is 115 V ~ 60 Hz.
Important: if you need to use and extension cord, please be sure to use a heavy duty extension cord (minimum 14 gauge).
Before connecting the Pinguino to power supply, make sure that all switches on the front control panel are in the OFF position.
Connect power cord found in storage compartment at rear of the
Pinguino.
fig. 9
8
