6
UNPACKING AND CLEANING
Carefully unpack the tool and all loose items from the shipping container(s). Peel protective film from the table surface.
Remove and clean the protective coating from the cutterhead. Remove the protective coating from all unpainted
surfaces. This coating may be removed with a soft cloth moistenedw ith kerosene (do not use acetone, gasoline or lacquer
thinner for this purpose). After cleaning, cover the unpainted sufaces with a good quality paste wax.
CAUTION: CARE MUST BE TAKEN WHENCLEANING THECUTTERHEAD AS THE KNIVES ARE SHIPPED IN
THE CUTTERHEAD AND THEY ARE VERYSHARP. Figs. 2 and 3, ILLUSTRATETHE PLANERAND ALL LOOSE
ITEMS SUPPLIEDWITH THE MACHINE.
1 - 12 Planer
2 - Chip Deflector
Fig. 2
Fig. 3
3 - Knife Setting Gage
4 - 8mm and 10mm
Open-End Wrench
5 - M5 x 20mm Hex
Socket Head Screw
6 - M5 Wing Nut (2)
7 - M5 Flat Washer (2)
8 - Elevating Handle
1
4
7
2
8
6
5
3