ADDITIONAL SAFETY RULES FOR GRINDERS
1.DO NOT OPERATE your tool until it is completely assembled and installed according to the instructions.
2.IF YOU ARE NOT thoroughly familiar with the oper- ation of grinders, obtain advice from your supervisor, instructor or other qualified person.
3.USE only grinding wheels rated for 3600 RPM with a 1/2" arbor hole. NEVER use a wheel rated lower than 3600 RPM or attempt to machine an undersize wheel to fit an arbor.
4.NEVER use a chipped or cracked grinding wheel. ALWAYS inspect each wheel before mounting on the grinder. REPLACE A CRACKED WHEEL IMMEDIATE- LY.
5.DO NOT overtighten wheel nut.
6.ALWAYS maintain a distance of 1/8" or less between the grinding wheel and the tool rest. Adjust the tool rests as the grinding wheels decrease in size with use.
7.SECURELY tighten tool rests so they cannot shift position while in use.
8.NEVER grind on a cold wheel. The grinder should always be started and run at idle speed for one full minute before applying work.
9.NEVER grind on the side of the wheel. ALWAYS grind on the face of the wheel only.
10.NEVER apply coolant directly to a grinding wheel. Coolant can weaken the bonding strength of the wheel and cause it to fail. Dip the workpiece into water to cool it.
11.SPARKS ARE A HAZARD! NEVER grind near flam- mable gas or liquids.
12.ALWAYS MAKE SURE the wheel guards and eye shields are in place, properly adjusted and secured.
13.KEEP the spark guards close to the wheel and re- adjust them as the wheel wears.
14.MAKE CERTAIN the blotter and wheel flanges furn- ished are used to mount the grinding wheels onto the grinder shaft.
15.STAND to one side of the wheel when turning on the power.
16.AVOID awkward hand positions where a sudden slip could cause a hand to move into the grinding wheel.
17.ALWAYS keep hands and fingers away from the grinding wheel.
18.NEVER start the grinder with the workpiece pressed against the grinding wheel.
19.DRESS the wheel on the face only. Dressing the side of the wheel can cause it to become too thin for safe use.
20.DO NOT use a wheel that vibrates. Dress the wheel, replace the wheel, or replace the shaft bearings, if worn.
21.GRINDING CREATES HEAT. Do not touch the
22.REDUCE THE RISK of unintentional starting. Make sure switch is in the “OFF” position during a power failure.
23.ALWAYS keep guards in place when using a wire brush or buffing wheel in place of the standard grinding wheel.
24.SHOULD any part of your tool be missing, damaged, or fail in any way, or any electrical component fail to perform properly, shut off switch and remove plug from power supply outlet. Replace missing, damaged or failed parts before resuming operation.
25.ADDITIONAL information regarding the safe and proper operation of this product is available from the National Safety Council, 1121 Spring Lake Drive, Itasca, IL
3
