ASSEMBLY INSTRUCTIONS
ASSEMBLING TOOL RESTS
1.Assemble adjustable tool rest (A) Fig. 1, to left side of tool rest arm (B), as shown, and fasten with one 3/4 inch- long hex head screw and lockwasher (C). Assemble the remaining tool rest to the right side of the other tool rest arm in the same manner. Do not completely tighten hard- ware at this time.
2.Assemble left tool rest assembly (D) Fig. 2, to the inside of left wheel guard (E), and fasten with two 5/8 inch- long screws and flat washers (F) as shown.
3.Assemble right tool rest assembly to the inside of right wheel guard and fasten with two 3/4
4.Each tool rest assembly (D) Fig. 2, is adjustable so it can be positioned slightly below the centerline of the wheel and as close to the grinding wheel as possible, giv- ing maximum support to the piece that is being ground. A distance of
ASSEMBLING SPARK GUARDS
The spark guard (A) Fig. 3, is to be mounted to the side of each wheel guard, using the 1/4
Fig. 1
Fig. 2
ASSEMBLING EYE SHIELDS
Your grinder is supplied with two safety eye shields for operator protection. To assemble the eye shields, proceed as follows:
1.Place shield (A) Fig. 4, under the lip of frame (B). Line up the two holes in the shield with the two holes in the frame and fasten together using two 1/2
A
E DC
B
D
E
A
Fig. 3 | Fig. 4 |
