Delta 23-880, 23-980 instruction manual Connecting Grinder to Power Source, Motor Specifications

2.Insert the short end of mounting rod (F) Fig. 5, into hole of frame (B) and fasten in place with 3/4 inch-long square necked round head screw (G) and nut (H).

3.Assemble long end of eye shield mounting rod (F) Fig. 6, to the side of each wheel guard using bracket (J), lockwasher and locking knob (L). The eye shield (A) is fully adjustable so it can be put in any position by moving the shield (A) or loosening locking knob (L) and repositioning rod (F).

Fig. 6

Fig. 5

Fig. 7

CONNECTING GRINDER TO POWER SOURCE

POWER CONNECTIONS

A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be protected with a 20 Amp fuse. Have a certified electrician replace or repair a worn cord immediately. Before connecting the motor to a power line, make sure the switch is in the ‘“OFF” position and be sure that the electric current is of the same characteristics as stamped on the motor nameplate. Running on low voltage will damage the motor.

WARNING: DO NOT EXPOSE THE TOOL TO RAIN OR OPERATE THE TOOL IN DAMP LOCA- TIONS.

MOTOR SPECIFICATIONS

Your grinder is wired for 110-120 volt, 60 HZ alternating current. Before connecting the grinder to the power source, make sure the switch is in the “OFF” position.