TILTING THE TABLE AND ADJUSTING THE 45 DEGREE POSITIVE STOPS
MAKE CERTAIN MACHINE IS DISCONNECTED FROM POWER SOURCE BEFORE MAKING ADJUST- MENTS.
The table can be tilted up to 45 degrees up or down. To tilt the table down as shown in Fig. 14, loosen table lock handles (A) Fig. 13, and pivot table until desired angle is established. Then tighten table locking handles. To tilt the table (X) up as shown in Fig. 17, loosen table lock handles (A) Fig. 13, pivot 90 degree positive stop (B) Fig. 15, to the position shown, and tilt the table to the desired angle. Then tighten table locking handles. NOTE: Table locking handles (A) Fig. 13, are
WARNING: REGARDLESS OF WHICH POSITION THE TABLE IS TILTED, THE TABLE EDGE (Z) FIG. 14, MUST BE POSITIONED A MAXIMUM OF 1/16" FROM THE ABRASIVE DISC AS SHOWN, TO AVOID TRAP- PING THE WORK OR FINGERS BETWEEN THE TABLE AND ABRASIVE DISC. FOR ADJUSTMENTS, SEE SECTION “ADJUSTING MITER GAGE SLOT PAR- ALLEL WITH THE ABRASIVE DISC”.
WARNING: WE SUGGEST THAT ALL BEVEL SAND- ING APPLICATIONS BE PERFORMED WITH THE TABLE TILTED DOWN AS SHOWN IN FIG. 14; HOW- EVER, IF THERE IS A NEED TO TILT THE TABLE UP AS SHOWN IN FIG. 17, THE WORKPIECE MUST BE SECURELY FASTENED OR CLAMPED TO A FIXTURE OR JIG TO PREVENT THE WORKPIECE FROM BEING TORN FROM HANDS AND BECOMING TRAPPED BETWEEN THE TABLE AND ABRASIVE DISC.
To check and adjust the 45 degree positive stops, pro- ceed as follows:
MAKE CERTAIN MACHINE IS DISCONNECTED FROM POWER SOURCE BEFORE MAKING ADJUST- MENTS.
1.Loosen table locking handles, one of which is shown at (A) Fig. 16, and tilt the table to the 45 degree down position as shown in Fig. 16, and tighten table locking handles. Place a square (E) Fig. 16, on the table and against the disc and check to see if the disc is 45 degrees to the table surface. If an adjustment is neces- sary, proceed as follows:
A
Fig. 13
Z
Fig. 14
C
X
B
D
Fig. 15
E
A
Fig. 16
8
