EXTENSION CORDS

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which has a 3-prong grounding type plug and a 3-pole receptacle which will accept the tool’s plug. When using an extension cord, be sure to use one heavy enough to carry the current of the saw. An undersized cord will cause a drop in line voltage, resulting in loss of power and overheating. Fig. 11, shows the correct gauge to use depending on the cord length. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

RECOMMENDED EXTENSION CORD SIZES FOR USE

WITH STATIONARY ELECTRIC TOOLS

Fig. 11

OPERATING INSTRUCTIONS

FOREWORD

Delta Model 36-070 is a 10" Power Miter Saw designed to cut wood. Cross cutting and miter cutting are easy and accu- rate. It can crosscut up to 2-1/4" x 5-3/4", miter at 45 both left and right 2-1/4" x 4-1/8". It has positive miter stops at 0, 22.5, and 45 degrees both left and right, and is accurate to one half degree.

7

Page 7
Image 7
Delta 36-070 instruction manual Extension Cords, Foreword